Reusable ultraviolet dosimetry badges have been developed that provide a visual indication of daily cumulative ultraviolet (UV) exposure. These two-sided, tapelike devices measure UV radiation emitted by sunlight or an artificial UV light source exposure by means of a photochromic aziridine color change reaction that is UV-integrating but optically reversible. UV radiation falling on the exposure side of the badge generates a color change that can be seen from the opposite or readout side. End points are indicated by a visual match of the photochromic with a surrounding reference. This paper describes the construction, component characteristics, and clinical testing of two versions of a new photochromic dosimeter that selectively responds to either UVB (280–320 nm) radiation or UVA (320–400 nm) radiation of the solar spectrum. One version of this monitor, sensitive only to the mid-range UVB, has a peak sensitivity to 300 nm and has four end point markers revealing color changes corresponding to 0.4, 0.8, 2.2, and 6.5 times the minimal erythema dose of an average Caucasian. A second version, sensitive only to UVA, has a peak sensitivity at 355 nm and can monitor exposures ranging from 0.8 to 10 joules/cm². Outdoor efficacy testing has shown that the UVB monitor is an effective predictor of UV dose—related 24-hour erythema response induced by sunlight. Following a measurement, these monitors can be rezeroed by exposing the readout side to sunlight for a few minutes. They can be reused for eight to ten times. The limitation of the sunlight-calibrated UVB monitor tag is its failure to predict erythema response produced by artificial UVB sources such as FS40 sunlamps.