S'abonner

Board Français d’Orthodontie - 26/05/10

Doi : 10.1016/j.ortho.2010.03.009 
Teresa Pinho
Instituto Superior de Ciências da Saúde-Norte/CESPU, Rua Central de Gandra, 1317, 4585-116 Gandra, PRD, Portugal 

Bienvenue sur EM-consulte, la référence des professionnels de santé.
L’accès au texte intégral de cet article nécessite un abonnement.

pages 15
Iconographies 9
Vidéos 0
Autres 0

Case No.: 290105. Date of birth: 15/05/1993; gender: male.

Summary

A. Pretreatment documents

1/2006 (age of patient: 12y8m).

Diagnosis

Facial examination:

convex profile with retrusive upper lip;
open nasolabial angle;
short, everted lower lip;
protruding chin;
balanced smile.

Functional examination

A complete examination was done. The painful signs observed at the two TMJs originated from a position high up and behind the mandibular condyles in the glenoid cavities, thus producing compression in the bilaminar regions.

Endooral examination and analysis of casts

All the permanent teeth were present.

We noted a bilateral canine and molar relationship with incisor deep bite.

The midlines were 2mm off-center with the maxillary midline to the right and the mandibular midline to the left of center.

There was no crowding in the upper arch. The lower arch displayed diastemas between 32, 41 and 42 and mild crowding between 32 and 33.

We observed a partial scissor-bite resulting from the coronobuccal tipping of 14 and 24, which were distally rotated, and from the coronolingual tipping of 34 and 44.

Overbite was 6.2mm and overjet 8.4mm.

The distal angle of 11 was chipped.

Panorex

All the wisdom teeth were present.

Cephalometric analysis

Cephalomtery enabled us to calculate:

a skeletal Class II with a retruded maxilla and even more pronounced mandibular retrognathism (ANB=7.6°; SNA=78.4° and SNB=70.8°) as confirmed by the Ao-Bo value (6mm);
skeletal normal bite (FMA=26.5°);
coronopalatal tipping of the upper incisors (UI/NA=15.4°), expression of compensation of the skeletal pattern with correct positions of the lower incisors (IMPA=89°);
a very open interincisor angle (I/I=140.2°) with a 6.2mm overbite and 8.4mm overjet.

Treatment

The severity of the malocclusion and the treatment planned in conjunction with the parents would depend on the patient’s foreseeable growth and on the evolution of his facial esthetics.

First phase: January 2006

In order to relieve the TMJs and treat the partial and bilateral scissor-bite, a maxillary plate with an inclined retroincisal plane was fitted to the banded maxillary first molars. Subsequently and gradually, the thickness of the inclined plane was raised to allow the mandible to recover its vertical contacts and move slightly forward. The non-occlusion achieved on placing this apparatus enabled spontaneous correction of the tipping of the first premolars and of the partial, bilateral scissor-bite occlusion.

One month later, the pain had disappeared in both TMJs.

Second phase: June 2006

The inclined retroincisal plane was kept in place for a further 6months.

When all the joint symptoms had disappeared and the situation had been consolidated by lateral and posterior dental contacts, a second complete examination was performed. This pointed to two possible protocols, either orthodontic treatment alone, or orthodontic-surgical treatment, the decision being dependent upon future growth.

As the parents refused the idea of surgery, we opted to undertake bimaxillary orthodontic treatment.

The treatment stages in order were: alignment, levelling, intrusion of upper and lower incisors, Class II elastics and finishing.

B. Posttreatment documents

6/2008 (age of patient: 15y1m).

Retention

Face analysis: concave profile but with indisputable esthetic improvement; the nose and chin had grown a lot but the smile was pleasant.

Functional examination

Joint examination (absence of pain and noises, etc.), muscle examination (symmetrical and synchronous during effort, absence of spasm) and the magnitude of the mandibular movements demonstrated the quality of the functional balance.

Endooral examination and analysis of casts

Stable and functional dental occlusion was obtained with a bilateral canine and molar Class I.

Alignment of the two midlines with the axis of the face.

Correction of the deep bite with normal overjet and overbite.

Panorex

Correct root positions, extraction of the third molars was advised.

Cephalometric analysis

Improved sagittal relationships with reduction of the Class II (the ANB angle reduced from 7.6° to 4.1° and the Ao-Bo from 6mm to 5.3mm) due to the closing of the SNA angle from 78.4° to 76.6° and the opening of the SNB angle from 70.8° to 72.5°.
Regarding the vertical dimension, the skeletal pattern as measured by the FMA had reduced from 26.5° to 24° but remained normodivergent.
Dentoalveolar compensations:
the angle formed by the upper incisors with the NB line increased considerably from 15.4° to 25.2° while the IMPA also increased from 89° to 91.8°;
the overjet and overbite decreased, respectively, from 8.4mm to 4.6mm and from 6.2mm to 4.1mm;
the intercisal angle closed from 140.2° to 131°, thus contributing to enhanced correction of the incisor overbite;
the occlusal plane underwent clockwise rotation.

Analysis of the superimpositions

General superimposition: we observed considerable horizontal mandibular growth with very significant development of all levels of the face, notably ample development of the nose and cutaneous chin, anticlockwise rotation of the occlusal plane due to growth of maxilla and mandible in the same direction.
Maxillary superimposition: the sagittal dentoalveolar adjustments went as planned; despite the use of Class II mechanics, the maxillary incisor torque increased; there was noticeable retrusion of point A.
Mandibular superimposition: some mandibular growth was expressed contributing to the correction of the skeletal and dental Class II as well as to the coronovestibular repositioning of the mandibular incisors.
In the vertical dimension, we observed good control over the occlusal plane and remodelling of the curve of Spee.

C. Postretention records

9/2009 (age of patient: 16y4m).

D. Clinical observations

The first orthopedic stage aimed to decompress the craniomandibular joints and reposition the mandibular condyles. This was done using an anterior bite plane.
The second phase was conducted using a bimaxillary appliance in order to obtain the necessary interdigitation to maintain the previously achieved mandibular position. To preserve this mandibular reference position, the anterior bite plane was left in place for 6months during wearing of the fixed bimaxillary appliance.
The length of treatment was due to the major mechanics required and to the uncertainty concerning the mandibular growth response. Thanks to exceptional compliance on the part of the patient, the achieved occlusion was highly satisfactory and stable.
The anterior bite plane was used to slightly advance the mandible. Class II intermaxillary elastics were also used at the end of treatment to maintain control over the anterior teeth.

Le texte complet de cet article est disponible en PDF.

Plan


© 2010  CEO. Publié par Elsevier Masson SAS. Tous droits réservés.
Ajouter à ma bibliothèque Retirer de ma bibliothèque Imprimer
Export

    Export citations

  • Fichier

  • Contenu

Vol 8 - N° 2

P. 190-204 - juin 2010 Retour au numéro
Article précédent Article précédent
  • Essai de modélisation de la forme d’arcade dentaire du sujet sénégalais
  • Khady Diop BA, Mouhammadou Mansour Faye, Soukèye Ndoye, Joseph Samba Diouf, Papa Ibrahima Ngom, Falou Diagne
| Article suivant Article suivant
  • Board Français d’Orthodontie
  • Teresa Pinho

Bienvenue sur EM-consulte, la référence des professionnels de santé.
L’accès au texte intégral de cet article nécessite un abonnement.

Bienvenue sur EM-consulte, la référence des professionnels de santé.
L’achat d’article à l’unité est indisponible à l’heure actuelle.

Déjà abonné à cette revue ?

Mon compte


Plateformes Elsevier Masson

Déclaration CNIL

EM-CONSULTE.COM est déclaré à la CNIL, déclaration n° 1286925.

En application de la loi nº78-17 du 6 janvier 1978 relative à l'informatique, aux fichiers et aux libertés, vous disposez des droits d'opposition (art.26 de la loi), d'accès (art.34 à 38 de la loi), et de rectification (art.36 de la loi) des données vous concernant. Ainsi, vous pouvez exiger que soient rectifiées, complétées, clarifiées, mises à jour ou effacées les informations vous concernant qui sont inexactes, incomplètes, équivoques, périmées ou dont la collecte ou l'utilisation ou la conservation est interdite.
Les informations personnelles concernant les visiteurs de notre site, y compris leur identité, sont confidentielles.
Le responsable du site s'engage sur l'honneur à respecter les conditions légales de confidentialité applicables en France et à ne pas divulguer ces informations à des tiers.


Tout le contenu de ce site: Copyright © 2024 Elsevier, ses concédants de licence et ses contributeurs. Tout les droits sont réservés, y compris ceux relatifs à l'exploration de textes et de données, a la formation en IA et aux technologies similaires. Pour tout contenu en libre accès, les conditions de licence Creative Commons s'appliquent.