Aim is to report on the results of an optimized balloon filling algorithm and suggest a refinement of the implantation approach to maximize safety. Appropriate sizing of balloon expandable valves during transcatheter aortic valve implantation is crucial. Study comprised 370 consecutive patients receiving SAPIEN 3 valve between 2015 and 2018. Valve expansion/recoil measurement in the inflow area, annular area, and outflow area was performed previously and postimplantation. Nominal balloon filling resulted in underexpansion—23 mm (20.96 mm), 26 mm (23.88 mm), and 29 mm (27.56 mm) SAPIEN 3 valves at the annular level. Increased balloon filling by 2 cc resulted in a gradual increase in valve diameter reaching 97.35% (23 mm), 96.50% (26 mm), and 96.11% (29 mm) of the nominal valve diameter. Final diameters were usually higher in the valvular inflow and outflow tracts. The 29 mm valve did not reach its nominal diameter with 2 cc overfilling and in none of inflow area (95.48%), annular area (96.11%), or outflow area (96.86%). Device success (by VARC II) was 96.2%. No root or septal rupture, device migration, mitral valve injury, coronary obstruction, or dissection occurred. Rate of new permanent pacemaker implantation was 8.3%. Paravalvular leakage was none or trace in most patients. Mean valve gradient was 10.77 mm Hg postprocedure. 1.9% of the patients had a maximum gradient of >40 mm Hg, 2.2% >20 mm Hg. In conclusion, an optimized balloon filling algorithm resulted in appropriate valve gradients, low levels of paravalvular leakage, low rates of permanent pacemaker implantation and no annular rupture.