Rehearsals using patient-specific 3D-printed aneurysm models for simulation of endovascular embolization of complex intracranial aneurysms: 3D SIM study - 25/01/23
Challenging embolization of complex intracranial aneurysms, with advanced devices (WEB, flow diverters).
Pre-operative rehearsals could be helpful for advanced device selection.
Patient-specific 3D-printed models bring haptic feedback and reliable model.
Implantation failure of advanced device and radiation dose of procedure could be reduced by EVIAS solution rehearsals.
In neurovascular treatment planning, endovascular devices to manage complex intracranial aneurysms requiring intervention are often selected based on conventional measurements and interventional neuroradiologist experience. A recently developed technology allows a patient-specific 3D-printed model to mimic the navigation experience. The goal of this study was to assess the effect of pre-procedure 3D simulation on procedural and clinical outcomes for wide-neck aneurysm embolization.
Materials & methods
In this unblinded, non-randomized, prospective, multicenter study conducted from November 18 through December 20, patients with complex intracranial aneurysms (neck > 4 mm or ratio < 21) were treated by WEB or flow diverter stents (FDS). The primary endpoint was concordance between simulation and procedure, 3D-printed model accuracy as well as embolization outcomes including complications, procedure times, and radiation dose were also assessed. Secondary endpoint was to compare versus a retrospective WEB cohort.
Twenty-one patients were treated, 76% of cases by WEB and 24% by FDS. Concordance between post-simulation and real procedure efficiency was 0.85 [0.69 – 1.00] for size device selection and 0.93 [0.79 – 1.00] for wall-apposition/aneurysm neck closure. Geometrical accuracy of the 3D-printed model showed a mean absolute shift of 0.11 mm. Two complications without major clinical impact were reported with a post-operative mRS similar to pre-procedure mRS for all patients.
Rehearsal using accurate 3D-printed patient-specific aneurysm models enabled optimization of embolization strategy, resulting in reduced procedure duration and cumulative fluoroscopy time which translated to reduced radiation exposure compared to procedures performed without simulation.Le texte complet de cet article est disponible en PDF.
Rehearsals Using Patient-Specific 3d-Printed Aneurysm Models For Simulation Of Endovascular Embolization Of Complex Intracranial Aneurysms: 3d Sim Study
Keywords : Interventional neuroradiology, Simulation, Intracranial aneurysm, 3D-printed
Vol 50 - N° 1P. 86-92 - février 2023 Retour au numéro
Bienvenue sur EM-consulte, la référence des professionnels de santé.
L’accès au texte intégral de cet article nécessite un abonnement.
Déjà abonné à cette revue ?