Effect of enamel surface pretreatment and thermocycling on shear bond strength of metallic orthodontic brackets bonded with a self-adhesive resin: An in vitro study - 19/11/26
, Isadora Da Silva Ximenes 1
, Vitor Hugo Queiroz de Barros 1
, Ranyele Elis Alexandre Rodrigues 1
, Ketelyn Kerty Moreira de Oliveira 1
, Vitaliano Gomes de Araújo-Neto 2
, Anderson Gomes Forte 2
, Tainah Oliveira Rifane 1, ⁎
, Alexandre Daher Yunes Salgado 1 
Highlights |
• | Airborne-particle abrasion (50-mm aluminium oxide particles at 2 bars, at 1 cm, for 10 s) significantly increased orthodontic bracket bond strength. |
• | Self-adhesive resin showed improved adhesion after enamel air abrasion. |
• | Thermocycling significantly reduced bond strength in all experimental groups. |
• | Combined acid etching and air abrasion did not outperform air abrasion alone. |
• | Air abrasion promoted more favourable adhesive failure patterns after debonding. |
Summary |
Objective |
This study evaluated the effect of different enamel surface treatments on the microshear bond strength and failure mode of orthodontic brackets bonded with a self-adhesive orthodontic resin before and after thermocycling.
Materials and methods |
Bovine enamel specimens were embedded in polyvinyl chloride tubes with chemically activated acrylic resin and allocated into four groups according to enamel surface treatment: self-adhesive resin (SAR), acid etching + SAR, airborne-particle abrasion + SAR, and acid etching + airborne-particle abrasion + SAR. Each group was divided into immediate and aged conditions ( n = 10). Acid etching was performed with 37% phosphoric acid for 30 s, and airborne-particle abrasion with 50-μm aluminium oxide for 10 s. Brackets were bonded using Ortholink One Step adhesive. Aged specimens underwent 20,000 thermal cycles (5–55 °C). Microshear bond strength was measured using a universal testing machine, and failure mode was assessed with the Adhesive Remnant Index. Data were analysed using Tukey's test (α = 0.05).
Results |
Both surface treatment and thermocycling significantly influenced bond strength. In the immediate condition, air-abraded groups showed the highest bond strength (8.16–8.55 MPa), significantly exceeding non-abraded groups (5.17–5.30 MPa; P < 0.001). After thermocycling, air-abraded groups maintained higher bond strength (5.24–5.89 MPa) than the self-adhesive resin group (2.57 ± 1.04 MPa; (F(1,41) = 42.68, P < 0.001). Thermocycling significantly reduced bond strength in all groups ( P ≤ 0.049). Non-air-abraded groups exhibited only ARI score 0 failures, whereas air-abraded groups showed mixed failure patterns.
Conclusion |
Airborne-particle abrasion significantly improved bracket bond strength to intact enamel when using a self-adhesive orthodontic resin, although thermocycling reduced adhesion regardless of surface treatment.
Le texte complet de cet article est disponible en PDF.Keywords : Orthodontic brackets, Enamel, Self-adhesive resin, Air abrasion, Aluminum oxide, Bond strength
Plan
Vol 25 - N° 1
Article 101274- mars 2027 Retour au numéroBienvenue sur EM-consulte, la référence des professionnels de santé.
L’accès au texte intégral de cet article nécessite un abonnement.
Déjà abonné à cette revue ?
