Treatment of skeletal class II growing patients often requires the use of functional appliances, aimed at promoting mandibular advancement. Among these, Herbst appliance is recommended for its effectiveness, efficiency, and reduced need for compliance. Despite its skeletal favourable effects, well-known dental compensations can occur, especially when the appliance is not used close to the pubertal peak: upper incisors retroclination, lower incisors proclination, upper molars distalization and lower molars mesialization could reduce the overjet needed for a proper mandibular advancement. To counteract these unfavourable effects skeletal anchorage could be crucial.

The aim of this case report is to describe and evaluate the effects of using a skeletally anchored Herbst appliance in an 18-year-old (CVM5) male patient with skeletal Class II malocclusion and a convex profile.

The treatment started with a tooth-bone-borne palatal expansion, then the upper arch was bonded with pre-adjusted ceramic brackets. After 2months, a Manni Telescopic Herbst (MTH) supported by 4 miniscrews (two in the maxilla and two in the mandible) was applied. To avoid anchorage loss, TADs were connected with elastic chains to the arches. Nine months later, the Herbst was removed, the lower teeth were bonded and the patient wore class 2 elastics to stabilise the occlusion.

After 24months the treatment goal was achieved with a considerable improvement of the profile and a clinically significant mandibular advancement (Pogonion moved forward 7mm). A one-year follow-up lateral X-rays showed a good stability of the result.